32
Installation GRS1020/1120/1030/1130
Release
03
01/2017
Mounting in a switch cabinet
Note: Install the device in the 19" switch cabinet using sliding or mounting
rails.
This provides a more stable position of your device in environments
subject to vibration.
For more information on sliding/mounting rails and how to install them,
please contact your switch cabinet manufacturer.
The devices are designed to be mounted in a 19" switch cabinet.
In the delivery state, there are 2 pre-mounted holding brackets on the
sides of the device.
Verify that there is sufficient ventilation. If required, install a fan to keep
the device from overheating.
Measure the depth of the 19" cabinet so that all the lines to be
connected can be fed in easily.
CAUTION
OVERHEATING OF THE DEVICE
When installing the device, ensure that the ventilation slots are not covered.
Failure to follow these instructions can result in injury or equipment
damage.
To Next Page
Loading...
