Entering the IP Parameters
10
2.2
Entering IP parameters via CLI
Basic - L3P
Release
4.0
11/07
Save the configuration entered using
copy system:running-config nvram:startup-configand
press the Enter key.
Confirm that you want to save it by pressing y.
After entering the IP parameters, you can easily configure the Switch via the
Web-based interface (see the "Web-based Interface" reference manual).
NOTE: Enter '?' for Command Help. Command help displays all options
that are valid for the 'normal' and 'no' command forms. For the
syntax of a particular command form, please consult the documen-
tation.
(Hirschmann PowerMICE) >en
(Hirschmann PowerMICE) #network protocol none
(Hirschmann PowerMICE) #network parms 149.218.112.105 255.255.255.0
(Hirschmann PowerMICE) #copy system:running-config nvram:startup-con-
fig
Are you sure you want to save? (y/n) y
Copy OK: 15811 bytes copied
Configuration Saved!
(Hirschmann PowerMICE) #
To Next Page
Loading...
