Configuring the ports
Basic - L3P
Release
4.0
11/07
3
With "Function on/off" you turn the PoE on or off.
With "Send Trap" you can get the Switch to send a trap in the follow-
ing cases:
– If a value exceeds/falls below the performance threshold.
– If the PoE supply voltage is switched on/off at at least one port.
Enter the power threshold in "Threshold". If this value is exceeded/
not achieved, the Switch sends a trap, provided that "Send trap" is
enabled. You enter the power threshold as a percentage of the nom-
inal power in relation to the power yielded.
"Nominal Power" displays the power that the switch nominally pro-
vides for all PoE ports together.
"Reserved Power" displays the maximum power that the Switch pro-
vides to all the connected PoE devices together on the basis of their
classification.
"Delivered Power" shows how large the current power requirement
is at all PoE ports.
The difference between the "nominal" and "reserved" power indicates
how much power is still available to the free PoE ports.
To Next Page
Loading...
Need help?
General
