Hisense Essense - Operation Instructions; Selecting Operation Modes and Fan Speed

Operation instructions
The operation modeis changed in sequence:
The fan speed is changed in sequence:
Selecting mode
FAN mode
Heating mode is NOT available for cooling only air conditioner.
At "FAN ONLY" mode, only "High","Medium" and "Low" are available.
At "DRY" mode, Fan speed is set at "AUTO” automatically, "FAN" button
is ineffective in this case.
Setting temperature
Turning on
SWING, SMART, TIMER ON, TIMER OFF, CLOCK, SLEEP and SUPER operation modes will be specified in the following pages.
Changing modes during operation, sometimes the unit does not response at once. Wait 3 minutes.
Wait 3 minutes before restarting the appliance.
During heating operation, air flow is not discharged at the beginning. After 2－5 minutes, the air flow will be discharged
until temperature of indoor heat exchanger rises.
16℃~30℃
Range of available set temperature
*HEATING, COOLING
DRY
-7 ~ 7
unable to set
FAN
ONLY
8
Operation modes
*Note: Heating mode is NOT available for cooling only models.
*Note:
Remote controller
At “Dry” mode, a decrease or rise of up to 7℃ can be set
with if you still feel uncomfortable.
Press button once
TEMP.
Press button .
Result :
OFF
FAN SPEED
OFF
Result :
MODE
Press button once by once
Press button once by once
Auto
High Medium
Low
HEATING
COOLING
DRY
FAN ONLY
Raise temperature setting by 1℃
Lower temperature setting by 1℃
TEMP.
Press button once
Result :
Result :
T he RUN indicator of the indoor unit lights up.
Result :
MODE
PRESS
FAN SPEED
PRESS