Hisense I6433C7 User Manual

Cleaning and maintenance
After each use, wait for the glass ceramic surface to cool down and clean it. Otherwise, all remaining
impurities will burn onto the hot surface the next time you use the hob.
For regular maintenance of the glass ceramic hob, use special care products that create a protective
film on the surface to prevent the dirt from sticking onto it.
Before each use of the glass ceramic surface, wipe off the dust or any other impurities that could
scratch the surface, from both the hob and the pan bottom.
INFORMATION!
Steel wool, coarse cleaning sponges, and abrasive powders may scratch the surface. The surface
may also be damaged by aggressive spray cleaners and unsuitable liquid cleaners.
Signage may be worn when using aggressive or abrasive cleaners or cookware with coarse or damaged
bottom.
Use a damp soft cloth to remove minor impurities. Then, wipe the surface dry.
Remove water stains with a mild solution of vinegar. However, do not use this solution to wipe the
frame (only with some models) as it may lose its sheen. Do not use aggressive spray cleaners or
descaling agents.
Use special glass ceramic cleaners for stubborn dirt. Observe the manufacturer's instructions. Be
sure to thoroughly remove any cleaner residues after the cleaning process as they may damage the
glass ceramic surface when the cooking zones heat up.
Remove stubborn and burnt residues with a scraper. Be careful when handling the scraper to prevent
injury.
INFORMATION!
The scraper is not included in appliance equipment.
INFORMATION!
Only use the scraper when dirt cannot be removed with a wet cloth
or special cleaners for glass ceramic surfaces.
Hold the scraper at the correct angle (45° to 60°). Gently press the
scraper against the glass and slide it over the signage to remove
the dirt. Make sure the plastic handle of the scraper (in some
models) does not come into contact with a hot cooking zone.
INFORMATION!
Do not press the scraper perpendicularly against the glass and do not scratch the hob
surface with its tip or blade.
Immediately remove any sugar or sugar-laden food from the glass ceramic hob using a scraper, even
if the hob is still hot, as sugar may permanently damage the glass ceramic surface.
23

Hisense I6433C7 Specifications

General

Hob type	Zone induction hob
Frame type	Frameless
Finish type	Gloss
Warming zone	Yes
Product color	Black
Hob width size	59.5 cm
Top surface type	Glass-ceramic
Appliance placement	Built-in
Cooking zone 1 type	Regular
Cooking zone 3 type	Large
Cooking zone 4 type	Simmer
Cooking zone 1 boost	2000 W
Cooking zone 1 power	1500 W
Cooking zone 1 shape	Round
Cooking zone 4 boost	1600 W
Cooking zone 4 power	1200 W
Warming zone position	-
Cooking zone 1 diameter	180 mm
Cooking zone 1 position	Left front
Cooking zone 2 position	Left rear
Cooking zone 3 diameter	210 mm
Cooking zone 3 position	Right rear
Cooking zone 4 diameter	145 mm
Cooking zone 4 position	Right front
Number of cooking zones	4 zone(s)
Number of warming zones	4
Cooking zone 1 power source	Gas
Cooking zone 2 power source	Electric
Number of gas cooking zones	0 zone(s)
Stop & Go function	No
Country of origin	Slovenia
Clock type	Electronic
Timer type	Digital
Control type	Touch
Display type	LED
Control position	Front
AC input voltage	220-240 V
AC input frequency	50 - 60 Hz
Connected load (gas)	0 W
Connected load (electric)	7200 W
Package depth	575 mm
Package width	640 mm
Package height	160 mm
Package weight	8100 g

Weight and Dimensions

Depth	520 mm
Width	595 mm
Height	58 mm
Weight	7600 g
Cord length	0 m
Installation compartment depth	490 mm
Installation compartment width	560 mm
Installation compartment height	74 mm