6.OPERATION
16
You may select the model in the following procedure:
1) Power on and turn the knob beyond “OFF” position to start the appliance. Select the
Spin program and press the Function button and Temperature button twice in sequence
in five seconds to enter model selection mode.
2)
The digitron will show the model parameters. Press the Speed button to select th
e
model. Press the Temperature button to save the parameters and exit the model selection
mode.
3) For the initial selection of model, sim
ply
press the Speed button to select the model.
For subsequent selection, you must press and hold the Speed button for three seconds
and select the model after the buzzer beeps.
4)
After the model is changed, you need to power on the appliance again to take ef
fect
the change.
5) Model parameters(needless):
WFMC6
010/WFMC6010S/WFMC6010T;
WFVC6010/WFVC6010S/WFVC6010T;
WFRC6010/WFRC6010S/WFRC6010T;
WFHC6010/WFHC6010S/WFHC6010T.
To Next Page
Loading...
