5. INSTALLATION AND TEST
12
5.2 CONNECT THE INLET HOSE
Verify that the rubber washer is inside of the valve
connector.
Tighten the inlet hose s necurely to prevent leaks.
5.3 CONNECT THE DRAIN HOSE
※The end of the drain hose should be placed less than 49” from the floor
5.4 CONNECT POWER PLUG
5.5 TEST OPERATION
Make sure that the hose is not twisted
Avoid submerging the end of the hose
Connect the power plug to the wall outlet
·Avoid connecting several electric devices,
as doing so may cause a fire
To Next Page
Loading...
