Hisense WFMC6010 - Special Function Mode

8.TEST MODE
26
program, press the “Temp. + Prewash” button and then press the
“Start/Pause” button once within 5 seconds, the machine will enter into the
“Special function mode” afterwards.
CAUTION：After the inspection is finished, please turn off the special function
mode (Test mode、Cycle mode), otherwise, it may lead to mal-operation of users
and further affect the normal usage of washing machine.
8.2.1 The display window displays Hisense version No.;
8.2.2 Press the “Temp.” button to select parameters (the parameter adjustment
screen will circularly display: equilibrium value 1-equilibrium value 2-equilibrium
value 3-equilibrium value 4-test function). Press the “Spin” button to turn on or
turn off the “Test mode”;
8.2.3 Press the “Start/Pause” button to exit the “Developer mode”, and the
program enters into the “Special function mode”. If there is not any key input for
30 seconds, the program will exit the “Special function mode”;
8.2.4 Test mode
When the “Test mode” is turned on and the program is running,
♦ Press the “Temp.” button to turn on/off the acceleration function;
♦ Press the “Spin” button to turn on/off the temperature display function;
♦ Continuously press the “Prewash” button to successively display the current
“equilibrium value, the current speed, the current water-level frequency, the
heater status (H0: No heating, H1: Heating), inertia, loop”.