6-3 Operation
Jump Starting the ATV
Avoid using an auxiliary booster located on
a battery charger to jump the ATV. It is
best to use another 12V battery such as a
car or ATV battery. If using a car battery
to jump the ATV, do not start the car or
have the car running while jumping. A
car running will put out to much power
which will damage the ATV. To jump the
ATV, please follow the instructions below.
1. Open battery cover.
2. Make sure the key to the ATV is turned
off.
4. Connect the positive (red) jumper
cable to the positive pole on the good
battery then place the other end of the
positive jumper cable on the ATV positive
pole on the drained battery.
Place the negative (black) jumper cable on
the good battery then place the other end
of the negative cable on a paint-less
location on the ATV. A paint-less location
will assure a good ground.
① Jumper cable positive pole
② Jumper cable negative pole
To Next Page
Loading...
