Operation 6-2
STARTING ENGINE
To start the engine
1. Make sure the hand brake lever is pulled
in and the parking brake is set before
attempting to start the engine.
2. Place the shift lever in neutral. Note:
ATV will not start unless it is in neutral
3. Place fuel valve to the “ON” position.
4. Place the emergency stop switch located
on the handlebars, to the “RUN” position.
6. Depress the start button engaging the
starter motor.
Note: Do not push the
start button more than 5 seconds at a time,
doing so, could damage the starter motor.
To Next Page
Loading...
