Periodic Maintenance and Adjustment 8-11
Spark Plug Gap
1. Use a thickness feeler gauge to inspect
the spark plug gap. If not within specification,
change the gap.
Clearance of spark plug gap
○
a
Clearance of spark plug
Re-install the inspected plug or new plug until
finger tight. Finish tightening plug with a
wrench. If the plug is a new plug, tighten
approximately 1/2 turn more with the wrench.
If plug is an old plug, tighten approximately
1/8 turn more with a wrench.
12.7 ft-lbf（1.75 m-kgf，17.5Nm）
Air Filter Removal and Cleaning
1. Locate the Air Filter housing under the
seat.
2. Remove screws (1) holding the air filter
cover in place.
① Air filter cover screws
To Next Page
Loading...
