8-12 Periodic Maintenance and Adjustment
3. Gently remove the sponge air filter
element from the air filter housing.
4. Gently clean the sponge air filter element
with water.
5. Squeeze out excess water from the
element. Allow the element to dry completely.
Using a low flash point solvent or
gasoline to clean the air filter element.
POSSIBLE HAZARDS
Can catch fire which could result in
severe injury
HOW TO AVOID THE HAZARDS
Use water to clean element.
CAUTION:
Be careful not to tear the element while
cleaning.
6. If air filter element is damaged, replace.
7. Apply Air filter oil to the sponge element
then squeeze out excess oil.
8. Re-install air filter element in air filter
housing
NOTE:
The air filter element should be cleaned
once every 20-40 hours. If ATV is ridden in
wet, muddy or dusty conditions, the air filter
element should be cleaned more often.
Each time the air filter is cleaned and
re-installed, the air filter housing should be
inspected for air leaks or damage of any
kind.
CAUTION:
Operating the ATV without the air filter
installed can cause severe engine damage.
Never operate the ATV with a damaged or
missing air filter element.
To Next Page
Loading...
