Periodic Maintenance and Adjustment 8-19
CAUTION:
Sealed battery need a special battery
charger. Using a common type of battery
charger will result in a shorter life.
2. Verify that cables are properly routed
when install battery to the vehicle.
① Negative ② Positive
Displace fuses
The main fuse and main fuse box are
placed at the rear portion of the ATV. To
access the fuse box shut off the main
switch. Follow the steps below to inspect
fuses:
1. Make sure key is in the OFF position.
CAUTION:
To avoid short circuits make sure the key is
in the OFF position.
2. Open fuse box and locate bad fuse (fuse
is bad if amperage bar in fuse is melted).
If unsure if fuse is bad, check fuse with a
fuse tester.
3. Replace fuse with a new one.
4. Once fuse is replaced, test new fuse
under load by turning on switch.
5. If fuse fails again, contact a service
center for repair. Do not continue to run
your ATV if a fuse continues to fail until a
service center has repaired the issue.
.
To Next Page
Loading...
