Cleaning and Storage 9-2
WARNING
POTENTIAL HAZARD
Diving the ATV with wet brakes
WHAT COULD HAPPEN
Poor braking performance which could
result in an accident.
HOW TO AVOID
After cleaning ATV, drive at slow
speeds and apply the brakes to allow
friction to dry out the pads. Make sure
brakes are working properly before
normal operation.
STORAGE
1. Fill the fuel tank with fresh gasoline and
fuel stabilizer (fuel stabilizer can be
purchased at your dealer or any motorcycle,
small engine or car parts store). Start
engine and allow to run for 5 minutes so the
stabilizer can disperse through the fuel tank
and carburetor.
Fuel Stabilizer:
To get the correct ratio of fuel stabilizer
to gasoline, follow the manufacture
instructions on the fuel stabilizer.
2. Change engine oil.
3. Remove spark plug and add a teaspoon of
SAE10W30 OR 10W40 motor oil in the spark
plug hole then re-install the spark plug.
4. Without attaching the spark plug cable to
To Next Page
Loading...
