button .
• For copying the picture that comes from the tuner,
select SCART 1.
Note :Scart-1 socket cannot be used as DTV output.
Please use Scart-2 instead.
Camera And Camcorder
To Connec t to AV Inp ut
Connect your camera or camcorder to A V input of the TV .
• Connect your equipment to the TV via VIDEO (yel-
low), AUDIO R (red) and AUDIO L (white) inputs.
You must connect the jacks into the input with the
same colour.
To Connect To S-VHS Input
Connect your camera or camcorder S-VHS input of
the TV.
• Connect your equipment to the TV via S-VHS input
and audio inputs of AV inputs by usi ng S -VHS
cables.
Connec t the Decoder to the Video
Recorder
Some video recorder s have a special Scart socket
for decoder.
• Connect a Scart cable to the Scart socket of your
decoder and to the special Scart socket of your video
recorder. Refer to the booklet of your video recorder.
Conne cting Headphones (optiona l)
Use the stereo headphone socket of the TV, to con-
nect headphones.
Note: If you want to connect more equipment to your
TV, consult your dealer.)
Conne cting S ubwoof er
Use Subwoofer Out socket to connect an external,
active subwoofer to the set to give a much deeper
bass effect.
Audio Line out
To connect the external speakers to your TV, use the
Headphone Line Out of the TV. Additionally, turn “Line
out” setting on in the “Sound Menu”.
Note: While watching PC or YPbPr sources, Lineout
selection could only be the current source.
Tips
Care Of The Screen
Clean the screen with a slightly damp, soft cloth. Do
not use abrasive solvents as they may damage the
TV screen coating layer.
Poor Picture
Have yo u selected the correct TV sy stem? Is your T V
set or house aerial located too close to non-earthed
audio equipment or neon lights, etc.?
Mountain s or hig h buildin gs can cause doub le pictures
or ghost images. Sometimes you can improve the pic-
ture quality by changing the direction of the aerial.
Is the picture or Teletext unrecognisable? Check if
you have entered the correct frequency.
The picture quality may degrade when two peripher-
als are connected to the TV at the same time. In such
a case, disconnect one of the peripherals.
No Picture
Is the aerial connected properly? Are the plugs con-
nected tightly to the aerial socket? Is the aerial cable
damaged? Are suitable plugs used to connect the
aerial? If you are in doubt, consult your dealer.
No Picture means that your TV is not receiving a
transmission. Have you selected the correct button
on the remote control?Try once more.
So und
You can not hear any sound. Did you perhaps inter-
rupt the sound, pressing the
button ?
Sound is coming from only one of the speakers.Is the
balance set to one extreme? See Sound menu.
Remo te Control
Your TV no longer responds to the remote control.
Perhaps the batteries are exhausted. If so you can
still use the local buttons at the bottom of the TV.
To Next Page
