Item Description
Boot disable: With a management module installed, but the
management module cannot start due to without required settings
Warning: A warning, with which the management module can
operate, is issued.
Failed: A failure, with which the management module cannot
operate, is issued. The management module has no redundancy.
-----: No management module is installed.
LID Shows an LID (Identification LED) state among the following states.
ON: Powered on.
OFF: Powered off.
-----: No management module is installed.
Hot standby
status
Shows the management module is active or standby.
Active: Powered on.
Standby: Powered off.
-----: No management module is installed.
Table 2-148 Action buttons at the bottom
Item Description
LID ON Turns on the LID (Identification LED) of a selected management module. With
no management module selected, the button is not available.
LID OFF Turns off the LID (Identification LED) of a selected management module. With
no management module selected, the button is not available.
Management module
This window shows the operation status of a selected management module,
hardware information. You can perform its operations.
2-132
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
