Hitachi Compute Blade 500 Series - Page 228

ServerConductor/Blade Server Manager
Table 2-276 Action combo box on the upper right
Item Description
Edit Port
number
Sets a port number for the management module to receive request
commands from SC/BSM.
Only if using a port number other than the default value: 21001, change
the port number.
Send Alert Sends alerts for the test of switching the active server blade at N+M cold
standby. Select one form the instant switching alert and delayed
switching alert.
Table 2-277 SC/BSM Servers items
Item Description
Server Name Specify a name of SC/BSM. Up to 15 alphanumeric characters including
symbols. The name is shown only on the management module console,
not on other consoles such as SC/BSM console.
IP Address Specify an IP address for SC/BSM.
Alert Port
Number
Specify the number of a SC/BSM port for the alert destination used by
the management module to notify alerts.
Only if using a port number other than the default value: 20079, change
the port number.
Alert Level Select one or more from three levels shown below.
All: Sends all level alerts including Failed, Warning, and Information.
2-218
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide