Item Description
Next Shows the LPAR manager
firmware version assigned to
the target server blade when
the server blade boots next
time.
Backup/Restore
LP Settings
2
Backup Settings Shows whether LPAR manager
configuration information is
backed up.
Executed: LPAR manager
configuration information is
backed up.
Unexecuted: LPAR manager
configuration information is not
backed up.
Restore Settings Shows whether LPAR manager
configuration information is
restored.
Executed: LPAR manager
configuration information is
restored up.
Unexecuted: LPAR manager
configuration information is not
restored.
Notes:
1. Shows the setting of LPAR manager firmware.
2. Shows whether LPAR manager configuration information is backed up/restored.
Table 2-76 Action button at the bottom
Item Description
Back Returns to the Assign firmware to Server Blade (Operating LPAR manager
configuration information) dialog box.
OK Assigns the LPAR manager firmware to the server blade.
Cancel Cancels the settings and closes the Assign firmware to Server Blade (Confirming)
dialog box.
Tip: The Assign firmware to Server Blade (Selecting LPAR manager F/W
version) dialog box or the Assign firmware to Server Blade(Operating LPAR
manager configuration information) dialog box can be shown by pressing
Back button. However, in the case that Back button is pressed on the Assign
firmware to Server Blade (Operating LPAR manager configuration
information) dialog box, the result whether LPAR manager configuration
information is backed up/restored is cleared. So, in this case, when the
Assign firmware to Server Blade (Confirming) dialog box is shown again, the
result will be "Unexecuted".
2-78
Operating the Web Console
Hitachi Compute Blade 500 Series Web Console User's Guide
To Next Page
Loading...
