Chapter 2 Specifications
2 – 70
Specifications
Item Specification
Number of control axes 1 axis
Highest frequency 400 k pulse/s
Capacity 256 points Positioning data
Setting procedure 1. Sequence program
2. Positioner (Note, a positioner is optional.)
Method 1. Absolute system
2. Absolute system + Increment system
3. Increment system
Positioning instruction 1. Pulse specifying
2. μm specifying
3. inch specifying
4. degree specifying
Speed instruction Automatic, manual, and homing
6.25 pulse/s to 400 k pulse/s
μm/s, inch/s, degree/s input function
Speed stage 10 stages
Acceleration and
deceleration system
Trapezoid acceleration and deceleration
S-curve acceleration and deceleration (3-stage acceleration and deceleration)
Acceleration and
deceleration time
1 to 65,535 ms
Backlash 0 to 255 pulse
High and low limit setting +2,147,483,647 to -2,147,483,648 pulse
Pulse output method 1. Pulse chain (CW/CCW)
2. Clock + direction signal (CK/Direction)
(DIP switch No.1 and No.2 set the choice of pulse output system and the
switching of each positive and negative logic.)
Positioning
Pulse output procedure 1. Open collector output (Photo-coupler insulation)
2. Line driver output (Photo-coupler insulation)
Homing function 1. Free home position
2. Low speed homing
3. High speed homing 1
4. High speed homing 2
5. Absolute value encoder homing
Teaching Possible
Manual (JOG) operation Pulse output by manual input signal
Operation when CPU has stopped Operation is possible via I/O set or using the positioner
Absolute value encoder input Supports to Σ series / Σ II series by Yasukawa Electric Co. and P series by
SANYO electric Co.
Internal current consumption
300mA maximum
(continued on the following page)
Note - When the CPU is stopped during operation, the motor decelerates and stops.
- The maximum travel per one movement is 2,147,483,647 pulses. If the operation is performed exceeding
the maximum travel, the motor decelerates and stops at the maximum travel position.
To Next Page
Loading...
