Figure C-16 Baying kit (detail B)
Rear baying instructions
1. Remove rear doors to access cabinet frames.
2. Look for a common notch in frames where the baying connection will be
made (one at bottom and one at the top).
3. When the cabinets are even, place the hex connecting bushing. Use a
4mm hex Allen tool to put an M6 cap screw through the frame open
square. This will align the internal slot to reach the hex bushing. (A
magnetic tool is recommended because screws may fall off inside the
frame cavity.)
4. Repeat step 3 with the rest of the screws and the bushing installation.
Rack information
C-31
Hitachi Unified Storage VM Block Module Hardware User Guide
To Next Page
Loading...
