Hitachi HUS VM - Safety and Environmental Information; Power Controls and Indicators

Safety and environmental information
Caution: Before operating or working on the HUS VM storage system, read
Chapter 3, Safety requirements on page 3-1, and the environmental
information in Appendix D, Regulatory Compliance on page D-1 in this
manual.
Power controls and indicators
The front panel of the HUS VM storage system controller includes a power
ON/OFF switch, and a set of indicator LEDs that show the system status. The
are located in the upper left corner of the controller, as shown in the following
figure. The table below it describe the controls and indicators.
Figure 5-1 Power controls and indicators
5-2
Power On/Off procedures
Hitachi Unified Storage VM Block Module Hardware User Guide