This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference, in
which case users will be required to correct the interference at their own
expense.
Electronic emissions testing
EMI testing was done with shielded cables. Therefore, in order to comply with
the FCC regulations, you must use shielded cables with your installation.
The EMI tests were done in the following configurations:
DKC710I-CBX+DKC+F710I-SBX
DKC710I-CBX+DKC+F710I-SBX+DKC-F710I-UBX
Copies of the Underwriters Laboratories EMI compliance certificates are
located at the end of this chapter.
If trouble occurs in another configuration, a user may be requested to take
appropriate preventive measures.
European Declaration of Conformity
Warning This equipment complies with the requirements relating to
electromagnetic compatibility, EN 55022 class A for ITE, the essential
protection requirement of Council Directive 89/336/EEC on the
approximation of the laws of the Member States relating to
electromagnetic compatibility.
"EINE LEICHT ZUGÄNGLICHE TRENN-VORRICHTUNG, MIT EINER KONTAKT-
ÖFFNUNGSWEITE VON MINDESTENS 3mm IST IN DER UNMITTELBAREN
NÄHE DER VERBRAUCHERANLAGE ANZUORDEN (4-POLIGE ABSCHALTUNG)."
Maschinen lärm informations verordnung 3. GSGV, 18.01.1991: Der
"höchste" Schalldruckpegel beträt 70 db (A) oder weniger gemäß ISO 7779
CLASS 1 LASER PRODUCT
WARNING: This is a Class A product. In a domestic environment this product
may cause radio interference in which case the user may be required to take
adequate measures.
D-4
Regulatory Compliance
Hitachi Unified Storage VM Block Module Hardware User Guide
To Next Page
Loading...
