●Set the print specifications 4-84
●When the conditions in the following table are met during mixed single/interlaced control, printing that
mixes single scan and interlaced is possible.
Conditions for interlaced printing at Mixed single scan and interlaced
No. Conditions Example of print data
1 Barcodes are not set.
2
When number of line is two or more, all fonts of
items in each column are the same.
3
Ink drop use is from 1/1 to 1/4.
(The high speed print is not applicable.)
(Column 1) (Column 2) (Column 3)
5
×8
7
×10 5×8
18
×24 7×10 5×8
Single scan Interlaced
●When the conditions in the following table are met during dot mixed interlaced, interlaced printing with
mixed dots is possible.
Conditions for interlaced printing at Dot mixed interlaced
No. Conditions Print example
1 All fonts of items in each column are the same.
2 Barcodes are not set.
3
Following (1) or (2) is satisfied in all columns.
(Interlaced printing is also possible when all
columns are configured only with the condition
(2).)
(1) When number of line is two or more
All fonts of items in each column are the
same.
(2) When number of line is one
The font of items is 12
×16 or 18×24.
4
Ink drop use is from 1/1 to 1/4.
(The High-speed print mode is not applicable.)
(Column 1)
(Column 2) (Column 3)
5
×8
7
×10 5×8
18
×24 7×10 5×8
Interlaced
●1-line columns with 12×16 or 18×24 font at Dot mixed interlaced will be split into 2-line (or 3-line) in
the IJP and printed. As a result of a sprit 1-line of 12
×16 or 18×24, borders of characters might look
being pushed down, and set the Line spacing only for the case.
But, uneven printing happens when product speed matching is used at low speed .
●The number of print formats that can be set with dot mixture is up to eight at all ink drop charge rules.
And the ink drop use can not be mixed.
●Ink Drop Charge Rule Precautions
Precautions
No. Precautions Conditions
1
The higher the speed the bigger misalignment of lines at high speed without
product speed matching.
Dot mixed
interlaced only
2
Uneven printing happens at divided positions when product speed matching
is used for 1-line printing at low speed.
Dot mixed
interlaced only
To Next Page
Loading...
Need help?
General
