●Backing up data to USB memory 7-35
(5) Copy data from the Upper model to the Lower model
●When the model combinations satisfy those tabulated below in Table 1, "Copy data" to the lower model is
available even if the Print data/User pattern is created on the upper model.
●Refer to "(3) Data copy operation" to copy data after data is stored in USB.
Table 1. Model combinations where Copy data is available
No. Model combinations
1
Copy data from Standard model to Basic model
[Example] Copy from 6-Lines Standard model to 3-Lines Basic model.
●When the Print data was created on the upper model and "Copy data" was executed to the lower model,
Print data is then classified into 3 different classifications as described in Table 2.
Table 2. Classifications of Print data
No. Classifications
Display color of Message name on
"Select message" screen
1
Print data created on the upper model can be used as is on
the lower model.
Black
2
Print data created on the upper model can be used on the
lower model by correcting a part of Print data setting.
Brown
3 Print data CANNOT be used on the lower model Red
[EXPLANATORY NOTES OF CLASSIFICATIONS(EXAMPLE)]
Classification No.1: 3-Lines Print data created on 6-Lines machine can be used as is on the 3-Lines machine.
Classification No.2: Print data of Free layout created on the Standard model can be used on the Basic model
by correcting the "Format Setup" to be set to [Individual setup].
Classification No.3: 6-Lines Print data created on the 6-Lines machine can NOT be used on 3-Lines machine.
To Next Page
Loading...
Need help?
General
