Hitachi IJ UX User Manual

9-3 ●Display when warning or fault was generated
===== Ink Jet Startup Confirmation =====186
The ink jet will be turned ON.
Solution To turn the ink jet ON, press <Ready>.
Close
Ready
Print description 2015.07.0712:45
Menu
Com=0
[Stop ]
Ink operating time １００(hours)
Cumulative op. time １００(hours)
Print count １０００(prints)
Ink pressure  ０．０００(MPa；standard value:０．２５０)
Change
message
Select
message
Overwrite
message
Adjustprint
parameters
Operation
management
Message name[ ]
− ＋
Current user ID : user2
Inter-
laced
Printcount
reset
Startup
Manual
Makeup
Ink
◆◆◆◆◆ Main Ink Tank Too Full002
The ink level in the main ink tank is too high.
Cause 1. The valve (MV2) or valve (MV7) is faulty.
2. The High Level sensor in the main ink tank is faulty.
Solution 1. Drain proper amount of ink in the main ink tank.
2. Check the High Level sensor.
3. Contact your local distributor.
Reset
Close
HELP
Ink Jet Startup Confirmation
The ink jet will be turned ON.
Solution 1. To change the printer status to Ready, press <Ready>.
2. To change the printer status to Standby, press <Eject ink>.
No.050
CONFIRMATION
×
Ready CancelEject ink
(3) When a mistake was generated or when processing judgment is prompted
(a) Previous HM I
●The contents of the confirmation message are described at the place of each operation.
Message No.
The name of the confirmation
message is displayed.
The description, cause,
and solution are displayed.
(4) Guidance for Fault / Waring
(a)Previous HMI
Press HELP , then the
guidance will appear.
Message No.
The name of the confirmation
message is displayed.
The description, cause,
and solution are displayed.
(b) New HMI

Hitachi IJ UX Specifications

General

Brand	Hitachi
Model	IJ UX
Category	Printer
Language	English