Hitachi RCIM-1.0FSRE - Page 160

5 Optional functions
Optional functions through Remote control
SMGB0137 rev.0 - 05/2021
150
Item Optional function
Individual
Setting
Settings Setting conditions Description
FA
Lock function for fan
speed selection
×
00 Function disabled
This function is used to prevent
changes to the fan speed.
01
Function enabled
(factory setting)
Fb
Lock function
for swing louvre
operation
×
00 Function disabled
This function is used to prevent
changes to the automatic louvre
operation.
01
Function enabled
(factory setting)
FC
Lower limit of setting
temperature for
cooling
(Minimum value of
setting temperature
allowed in cooling)
×
00
Function disabled
19 °C is the standard minimum set
point. (factory setting)
This function denes the lowest
temperature setting value for FAN/
COOL/DRY modes.
01 +1 ºC (Lower limit 20 ºC)
02 +2 ºC (Lower limit 21 ºC)
03 +3 ºC (Lower limit 22 ºC)
·
·
·
·
·
·
08 +8 ºC (Lower limit 27ºC)
09 +9 ºC (Lower limit 28 ºC)
10 +10 ºC (Lower limit 29 ºC)
Fd
Upper limit of setting
temperature for
heating
(Maximum value of
setting temperature
allowed in heating)
×
00
Function disabled
30 ºC is the standard maximum set
point. (factory setting)
This function denes the highest
temperature setting value for
HEATING mode.
Models:
RPF(I)-FSN2E
up to 20ºC (FC=10)
01 -1 ºC (Upper limit 29 ºC)
02 -2 ºC (Upper limit 28 ºC)
03 -3 ºC (Upper limit 27 ºC)
·
·
·
·
·
·
10 -10 ºC (Upper limit 20 ºC)
11 -11 ºC (Upper limit 19 ºC)
12 -12 ºC (Upper limit 18 ºC)
FE
Not used -
00
- Use at 00 conditions
01
02
FF
Not Used -
00
- Use at 00 conditions
01
H1
No indication of
maintenance alarm
×
00 Displayed This function is used to display
or hide the maintenance alarm
indication.
01 Hidden
H2
Indication of hot
start
(No Indication of
operation limitation)
×
00 Displayed
This function is used to display or
hide the automatic control indication.
Models:
RPF(I)-FSN2E
Not available, use at 00 conditions
01 Hidden
H3
Operation mode
change restriction
×
00 Unlimited operation
? NOTE
“01” is available only when one
controller is used. Do not use this
setting when two controllers are
used.
01
Operation mode set by central
control equipment + “Fan” mode
02
Operation mode change not
available (Hide operation mode)
(Factory setting)