19
B023 Deceleration rate at overload restriction 1.0 / 30.0
B031 Software lock mode selection
• 00 Low-level access, [SFT] blocks edits
• 01 Low-level access, [SFT] blocks edits
(except F001 and Multi-speed parameters)
• 02 No access to edits
• 03 No access to edits except F001 and Multi-
speed parameters
01
B080 [AM] analog signal gain 100.
B082 Start frequency adjustment 0.5
B083 Carrier frequency setting 5.0
B084 Initialization mode (parameters or trip history)
• 00 Trip history clear
• 01 Parameter initialization
• 02 Trip history clear and parameter
initialization
00
B085 Country code for initialization
• 00 Japan version • 01 Europe version
•02USA version
01 / 02
B086 Frequency scaling conversion factor 1.0
B087 STOP key enable
• 00 Enable • 01 Disable
00
B088 Restart mode after FRS
• 00 Restart from 0Hz
• 01 Restart from frequency detected from
actual speed of motor
00
B090 Dynamic braking usage ratio 0.0
B091 Stop mode selection
• 00 DEC (decelerate and stop)
• 01 FRS (free-run to stop)
00
B092 Cooling fan control
• 00 Fan always ON
• 01 Fan ON during Run, OFF during Stop
• 02 Fan is temperature-controlled
00
B095 Dynamic braking control
•00Disable
• 01 Enable during RUN only
• 02 Enable always
00
B096 Dynamic braking activation level 360 / 720
B130 Over-voltage LADSTOP enable
• 00 Disable • 01 Enable
00
Func.
Code
Name / Description
Default
Value
–FEF / –FU
Set
Value
To Next Page
Loading...
