6
• Parameter Display – A 4-digit, 7-segment display for parameters and
function codes.
• Display Units: Hertz/Amperes – One of these LEDs will be ON to
indicate the units associated with the parameter display.
• Power LED – ON when the power input to the inverter is ON.
• Alarm LED – ON when the inverter in Trip Mode.
• Function Key – This key is used to navigate through the lists of
parameters and functions for setting and monitoring parameter values.
• Up/Down Keys – Use these keys alternately to move up or down the
lists of parameter and functions shown in the display, and to increment/
decrement values.
• Store Key – When the unit is in Program Mode and the operator has
edited a parameter value, press the Store key to write the new value to
the EEPROM.
To Next Page
Loading...
