Hitachi SPX-WKT2 - SLEEP TIMER OPERATION (Functions Menu)

NOTE
• When the mer is set, this remote controller will send the
sleep mer informaon to indoor unit and the mer lamp
of indoor unit turns on.
" "," " will be indicated when
the sleep mer operaon starts.
5 Select "Yes" by pressing "" or "" and press "OK".
The seng will be confirmed and the sleep mer operaon will
be started, then the screen will return to the normal mode.
4 Press "OK" to finish the sleep mer seng.
The confirmaon screen will be displayed.
NOTE
• You can set the me of the sleep mer operaon within the
me range before "ON" mer (Simple mer) preset me.
3 Press "" or "" to set each seng content for the selected
item. When "Timer Op." is selected, the seng contents are
switched in order of "Not Used" <---> "Used" by pressing ""
or "". When "Set me" is selected, the seng me can be
set "1 hour", "2 hours", "3 hours" and "7 hours" by pressing
"" or "" cyclically.
2 Press "" or "" to select the seng items. The seng
items are displayed "Timer Op." and "Set me".
NOTE
• If the present me has not been set yet, automacally
"Adjusng Date/Time" will be displayed.
• In this case, " " is indicated on LCD of the normal mode.
• Refer to "Adjusng Date/Time" secon of this manual.
1 Select "Sleep Timer" from the menu and press "OK".
The sleep mer seng will be displayed.
This funcon is Off Timer operaon to stop the operaon if
preset me has passed when you sleep.
5.3 SLEEP TIMER OPERATION ("Funcons" menu)
- 10 -