Hitachi SPX-WKT2 - CLEAN OPERATION; Starting Clean Mode

– When starts "Clean" operaon, operaon is limited to
"Fan" operaon.
– When one room operates "Clean" operaon first, other
rooms can operate "Cooling", "Dehumidifying" or "Fan"
operaon. However, when other rooms need to operate
"Heang" operaon, air condioner will be in STANDBY
mode. Aer "Clean" operaon finish, "Heang"
operaon will start.
NOTE
• When clean operaon is finished, unit will stop automacally.
• If Weekly Timer or Simple Timer is set, there is a need to
cancel those mers before operang "Clean" funcon.
• For mul connecon :
The clean operaon will be stopped and the screen will
be displayed the normal mode.
• Select "Clean" from the menu and press "OK".
The confirmaon screen will be displayed.
Select "Yes" by pressing "" or "" and press "OK".
• Press " " (START/STOP). Or
5.9.2 To cancel "Clean" operaon
• Total me taken for "Clean" operaon is 60 minutes.
• During this operaon, Heang or Fan operaon shall
operate.
• During this operaon, the operaon lamp of indoor unit
is blinking.
2 Select "Yes" by pressing "" or "" and press "OK".
The seng will be confirmed and the clean operaon will
be started, then the screen will be displayed the clean
operaon mode.
1 When unit is OFF, select "Clean" from the menu and press
"OK". The confirmaon screen will be displayed.
5.9.1 To start "Clean" operaon
Drying indoor heat exchanger aer cooling operaon to
prevent mildew.
5.9 CLEAN OPERATION ("Funcons" menu)
- 19 -
English