Hitachi SPX-WKT2 - OPERATION LOCK FUNCTION; Setting Operation Mode Lock

NOTE
• This funcon will not acvate if "Timer" reservaons acvate.
"Timer" reservaons shall be deacvated first.
Then, this funcon can be acvated.
• If power failure happens, the lock seng will disappear. You
may need to set again.
• For mul connecon, unit and mode which is set to lock
"Heang" and switched on first shall have higher priority.
Other units which are chosen to operate at different modes
shall be in "Standby" unl either the first unit operaon is
switched off or the model is selected to be same as the first
unit.
ex. Select "Cooling" mode lock
The operaon lock will be set and " " will be indicated on
the screen of normal mode.
3 Select "Yes" by pressing ""or "" and press "OK".
When "Heang" mode lock is selected
When "Cooling" mode lock is selected
When this funcon is not used
2 By repeatedly pressing ""or "", the indicaon is changed
in order of "No Seng" <---> "COOL" <---> "HEAT"
Select the funcon target and press "OK".
The confirmaon screen will be displayed.
When "filter sign" is turned on
The menu of normal screen
1 When unit is OFF, select "Lock" from the menu and press
"OK". The screen of "Mode Lock" selecon will be displayed.
This funcon is used to lock the operaon mode from the
remote controller.
The remote controller can be set to fix the "Heang" mode
(including "Fan"), "Cooling" mode and "Dehumidifying" mode
(including "Fan") operaons.
5.10 OPERATION LOCK ("Funcons" menu)
- 20 -