Hitachi SPX-WKT2 - BASIC OPERATION METHODS; Starting and Stopping Operation; Mode Selection and Temperature Adjustment

2 By pressing "", the temperature is increased by 1°C.
(Max. 32°C)
By pressing "", the temperature is decreased by 1°C.
(Min. 16°C)
Keep pressing and the value will change more quickly.
1 Press "" or "" and select "TEMP".
4.4 ROOM TEMPERATURE SETTING
• Automac Operaon (AUTO)
To cooling and heang at automac changeover depending
on the current room temperature.
However, the mode of operaon will not change, when the
indoor unit is connected to mul type outdoor unit.
Temperature range can be set between 16°C and 32°C.
• Heang Operaon (HEAT)
To increase the room temperature.
Temperature range can be set between 16°C and 32°C.
• Dehumidifying Operaon(DRY)
To decrease the humidity in the room.
Temperature range can be set between 16°C and 32°C.
• Cooling Operaon (COOL)
To decrease the room temperature.
Temperature range can be set between 16°C and 32°C.
• Fan Operaon (FAN)
To circulate the air in the room.
3 MODE Funcon
2 By pressing "" or "", the operaon mode will be
changed as follows.
1 Press "" or "" and select "MODE".
4.3 OPERATION MODE SELECT
2 Changing Seng
When the item ("MODE", "SPEED", "SWING" OR "TEMP") is
selected, press "" or "". The seng will be changed.
1 Item Selecon
By pressing "" or "" , the icon " " will move to the
next item in order of the indicaons "MODE", "SPEED",
"SWING" and "TEMP".
4.2 BASIC OPERATION
2 Operaon stop
Press " " (START/STOP) again. The operaon indicator lamp
will be turned off and the operaon will be stopped.
1 Operaon start
Press " " (START/STOP). The operaon indicator lamp
will be turned on and the operaon will be started.
4.1 OPERATION START/STOP
4. OPERATION METHOD
- 6 -
FANCOOLDRYHEATAUTO