Hitachi SPX-WKT2 - Fan Speed and Swing Control

NOTE
• During cooling and dehumidifying operaon, do not keep the
deflectors swinging or in the lower posion (in the case of
vercal auto swing) for a long me.
• It may cause dew condensaon on the deflectors.
The display for models of vercal
swing only
The display for models of vercal
and horizontal swing
• VERTICAL SWING
Press "". The deflector(s) will start to swing up and down.
Press "" again. The deflector(s) will stop in the current
posion.
• HORIZONTAL SWING
Press "". The deflectors will start to swing right and le.
Press "" again. The deflectors will stop in the current
posion.
2 To start/cancel auto swing operaon
NOTE
• For the indoor unit without the auto swing operaon, the
indicaon of "SWING" will not be displayed on LCD.
The display for models of vercal
swing only
The display for models of vercal
and horizontal swing
1 Press " " (START/STOP). Make sure that the operaon
started.
Press "" or "" and select "SWING".
4.6 AUTO SWING OPERATION
NOTE
• The fan speed of dehumidifying operaon can select "LOW"
and "SILENT" only.
• The fan speed of fan operaon cannot select "AUTO".
2 By pressing "" or "", the operaon mode will be changed
as follows.
1 Press "" or "" and select "SPEED".
4.5 FAN SPEED SELECT
- 7 -
English