Hitachi UX Twin Nozzle - Page 21

19
Holding Register data configuration (5/13)
Word
address
Classification Item name Setting range Contents
19 C0
Calendar
condition
Offset(Year) 0 to 99
Sets the offset of the Calendar
block 1.
19 C1 Offset(Month) 0 to 99
19 C2 Offset(Day) 0 to 1999
19 C3 Offset(Hour) -23 to 99
19 C4 Offset(Minute) -59 to 99
19 C5 Zero-suppression(Year) 0 to 2
Sets the zero-suppression of the
Calendar block 1.
0:Disable , 1:Enable(Space)
2:Enable(Character fill)
19 C6 Zero-suppression(Month) 0 to 2
19 C7 Zero-suppression(Day) 0 to 2
19 C8 Zero-suppression(Hour) 0 to 2
19 C9 Zero-suppression(Minute) 0 to 2
19 CA Substitution rules(Year) 0 , 1
Sets the substitution rules of the
Calendar block 1.
0:Disable , 1:Enable
19 CB Substitution rules(Month) 0 , 1
19 CC Substitution rules(Day) 0 , 1
19 CD Substitution rules(Hour) 0 , 1
19 CE Substitution rules(Minute) 0 , 1
19 CF Substitution rules No. 1 to 99
Sets the substitution rules No. of
the Calendar block 1.
19 D0
Substitution rules
(Week number)
0 , 1
Sets the substitution rules of the
Calendar block 1.
19 D1
Zero-suppression
(Week number)
0 to 2
Sets the zero-suppression of the
Calendar block 1.
19 D2
Substitution rules
(Day of week)
0 , 1
Sets the substitution rules of the
Calendar block 1.
19 D3
Zero-suppression
(Day of week)
0 to 2
Sets the zero-suppression of the
Calendar block 1.
19 D4
Output during calendar
updating Trigger
(Function item for SOP-05)
1 [1] Fixed
19 D5 Reserve_1
-
"Reserve" is not initially provided,
but may be added in future.
… …
19 DF Reserve_11
19 E0
Calendar condition
(Calendar block 2)
-
Block 2 through 8 will be set in the
same configuration as those of
Block 1 (Address: from 0x19C0 to
0x19DF).
19 FF
… …
1A A0
Calendar condition
(Calendar block 8)
1A BF