Hitachi WL200 Series - 5.3 A system configuration of the PROFINET

16
Using the Front Panel Keypad
Please take a moment to familiarize yourself with the keypad layout shown in the figure
below. The display is used in programming the inverter’s parameters, as well as monitoring
specific parameter values during operation.
Key and Indicator Legend
Items
Contents
(1) POWER LED
Turns ON (Green) while the inverter is powered up.
(2) ALARM LED
Turns ON (Red) when the inverter trips.
(3) Program LED
Turns ON (Green) when the display shows changeable parameter.
Blinks when there is a mismatch in setting.
(4) RUN LED
Turns ON (Green) when the inverter is driving the motor.
(5) Monitor LED [Hz]
Turns ON (Green) when the displayed data is frequency related.
(6) Monitor LED [A]
Turns ON (Green) when the displayed data is current related.
(7) Run command LED
Turns ON (Green) when a Run command is set to the operator. (Run key is effective.)
(8) 7-seg LED
Shows each parameter, monitors etc.
(9) RUN key
Makes inverter run.
(10) STOP/RESET key
Makes inverter decelerates to a stop.
Reset the inverter when it is in trip situation
(11) ESC key
Go to the top of next function group, when a function mode is shown
Cancel the setting and return to the function code, when a data is shown
Moves the cursor to a digit left, when it is in digit-to-digit setting mode
Pressing for 1 second leads to display data of , regardless of current display.
(12) Up key
(13) Down key
Increase or decrease the data.
Pressing the both keys at the same time gives you the digit-to-digit edit.
(14) SET key
Go to the data display mode when a function code is shown
Stores the data and go back to show the function code, when data is shown.
Moves the cursor to a digit right, when it is in digit-to-digit display mode
(15) USB connector
Connect USB connector (mini-B) for using PC communication
(16) RJ45 connector
Connect RJ45 jack for remote operator
(17)Remote Operator
Keys on the front panel don’t work while the remote operator is connected ([STOP] can be
validated). What to display on the 7-seg can be set with parameter
1
2
RUN
ESC
STOP
RESET
SET

(1) POWER LED
(2) ALARM LED
(8) 7-seg LED
(4) RUN LED
(10) STOP/RESET key
(15) USB connector
(3) Program LED
(16) RJ45 connector
(14) SET key
(13) Down key
(12) Up key
(11) ESC key
(9) RUN key
(7) Run command LED
(5) Monitor LED [Hz]
(6) Monitor LED [A]
RUN
PWR
Hz
ALM
A
PLG