Hitachi WL200 Series - Drive Parameter Setting Tables; Monitoring functions

47
Drive Parameter Setting Tables
Monitoring functions
NOTE: Parameters marked with "" in A column are accessible even in inverter running.
Parameters marked with "" in B column are accessible even in inverter running when in
the high level access mode, which means that b031 is set to "10".
* Please change from" (Basic display)" to " (Full display)" in parameter  (Function
code display restriction), in case some parameters cannot be displayed.
IMPORTANT
Please be sure to set the motor nameplate data into the appropriate parameters
to ensure proper operation and protection of the motor:
 b012 is the motor overload protection value
 A082 is the motor voltage selection
 H003 is the motor kW capacity
 H004 is the number of motor poles
Please refer to the appropriate pages in this guide and the Instruction Manual for further details.
“d” Function
A
B
Units
Func.
Code
Name
Description

Output frequency monitor
Real time display of output frequency
to motor from
0.00 to 400.0Hz
If  is set high, output frequency
() can be changed by up/down
key with d001 monitoring.


Hz

Output current monitor
Filtered display of output current to
motor, range is
0.0 to 655.3 Ampere


A

Rotation direction monitor
Three different indications:
“”Forward
“”Stop
“”Reverse




Process variable (PV),
PID feedback monitor
Displays the scaled PID process
variable (feedback) value ( is
scale factor),
0.00 to 9999.00


% times
constant

Intelligent input
terminal status
Displays the state of the intelligent
input terminals:



ON
OFF
7 6 5 4 3 2 1
Terminal numbers