Hitachi WL200 Series - Chapter 9 Errors and Remedies

52
“A” Function
A
B
Defaults
Func.
Code
Name
Description
Initial data
Units

[O] input active range
start voltage
The starting point (offset) for
the active analog input range,
range is 0. to 100 %.


0.
%

[O] input active range
end voltage
The ending point (offset) for
the active analog input range,
range is 0. to 100.%


100.
%

[O] input start frequency
enable
Two options; select codes:
Use offset ( value)
Use 0 Hz


01


Analog input filter
Range n = 1 to 31,
1 to 30 : ×2ms filter
31: 500ms fixed filter with ±
0.1 kHz hysteresis.


8.
Spl.

EzSQ function select
Select codes:
Disable
Activate by PRG terminal
Activate always


00
-

Multi-speed operation
selection
Select codes:
...Binary operation (16
speeds selectable with 4
terminals)
...Bit operation (8 speeds
selectable with 7
terminals)


00
-

Multi-speed freq. 0
Defines the first speed of a
multi-speed profile, range is
0.00 / start frequency to 400
Hz


6.0
Hz

Multi-speed freq. 0,
2
nd
motor
Defines the first speed of a
multi-speed profile or a 2nd
motor, range is 0.00 / start
frequency to 400 Hz


6.0
Hz

to

Multi-speed freq. 1 to
15
(for both motors)
Defines 15 more speeds,
range is 0.00 / start frequency
to 400 Hz.
=Speed 1 to
=Speed15


0.0
Hz


Jog frequency
Defines limited speed for jog,
range is from start frequency
to 9.99 Hz


6.00
Hz

Jog stop mode
Define how end of jog stops
the motor; six options:
Free-run stop (invalid
during run)
Controlled deceleration
(invalid during run)
DC braking to
stop(invalid during run)
Free-run stop (valid
during run)
Controlled deceleration
(valid during run)
DC braking to stop(valid
during run)


04
