Hitachi X200 Series User Manual

Miscellaneous Functions
The following table contains miscellaneous functions not in other function groups.
“C” Function Defaults
Func.
Code
Name /
SRW Display
Description
Run
Mode
Edit
-FE
(EU)
-FU
(USA)
Units
Debug mode enable *C091
DBG Slct OFF
Displays debug parameters.
Two option codes:
00}Disable
01}Enable <
Do not set>
(for factory use)
9
00 00

Up/Down memory mode
selection
C101
UP/DWN NO-STR
Controls speed setpoint for the
inverter after power sycle.
Two option codes:
00}Clear last frequency (return to
default frequency F001)
01}Keep last frequency adjusted
by UP/DWN
U
00 00

Reset selectionC102
RS Slct ON
Determines response to Reset
input [RS].
Three option codes:
00}Cancel trip state at input
signal ON transition, stops
inverter if in Run Mode
01}Cancel trip state at signal
OFF transition, stops inverter
if in Run Mode
02}Cancel trip state at input ON
transition, no effect if in Run
Mode
U
00 00

CAUTION: Do not change Debug mode for safety reasons. Otherwise unexpected
performances may occur.
362
Configuring Drive
Parameters
3
−
62
&RQ¿JXULQJ'ULYH
Parameters

Hitachi X200 Series Specifications

General

Series	X200
Output Frequency	0-400 Hz
Cooling Method	Fan Cooled
Type	Inverter
Control Method	V/F control
Overload Capacity	150% for 60 seconds
Braking Unit	Built-in
Communication	RS485, Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Overheating, Short Circuit
Ambient Temperature	-10°C to +50°C
Humidity	5 to 95% RH (Non-condensing)
Enclosure Rating	IP20
Operating Temperature	-10°C to +40°C
Storage Temperature	-20°C to +60°C