Maintenance—Every 2000 Hours
TX14740,0001F9C –19–16APR07–1/1
Change Travel Gearbox Oil
T134964 –UN–01NOV00
1—Fill Plug
2—Check Plug
3—Drain Plug
4—Horizontal Centerline
1. Park the machine on level ground rotating travel
gearbox until bottom of the oil level check plug (2) is
even with the horizontal centerline (4).
2. Stop engine.
CAUTION: Release of hot oils from sealed
system can cause serious burns. Wait for travel
gearbox oil to cool. Keep body and face away
from check plug. Gradually loosen check plug
to release pressure.
3. After travel gearbox has cooled, slowly loosen check
plug to release pressure.
Zaxis 200LC, 250—Specification
Travel Gearbox—Oil Capacity
(each) 5.2 L (1.4 gal)...................................................................................
7.5 L (2 gal) (High Drawbar)
Zaxis 350—Specification
Travel Gearbox—Oil Capacity
(each) 7.5 L (2.0 gal)...................................................................................
8.5 L (2 25 gal) (High Drawbar)
4. Remove drain plug (3). Allow oil to drain into a
container. Dispose of waste oil properly.
5. Wrap threads of drain plug with a sealing-type tape.
Install plug. Tighten plug to 49 N•m (430 lb-in.).
6. Remove oil fill plug (1).
7. Add oil until oil flows out of oil level check plug hole.
(See Section 3-1.)
8. Wrap threads of check plug and fill plug with
sealing-type tape. Install plugs. Tighten plugs to 49
N•m (36 lb-ft).
9. Change oil of second travel gearbox.
OUT1739,0000241 –19–16JUN06–1/1
Clean the Engine Crankcase Ventilation Tube
Clean the engine crankcase ventilation tube when you
measure and adjust engine valve clearance (lash).
3-11-4 081407
PN=148
To Next Page
Loading...
Need help?
General
