Miscellaneous—Machine
OUT1739,000024B –19–16JUN06–1/1
Check and Clean Windshield Regularly
CAUTION: DO NOT replace polycarbonate
windows with glass or plastic. Polycarbonate
material impact resistance is recommended
for forestry use.
The windshield is a polycarbonate material which is
softer but stronger than glass. It will scratch.
Before washing, flush as much loose dirt off as
possible with water. Some of the several commercially
available water soluble cleaners that do a good job of
cleaning the windows are liquid Ajax with Ammonia,
Joy, Fantastick, Top Job, Mr. Clean, Formula 409 or
other similar compounds. If there is a heavy
concentration of tree sap, use No. 1 or No. 3
denatured alcohol, Varsol No. 2 or rubbing alcohol,
followed by a water soluble cleaner. To remove paint,
use butyl cellosolve (2-Butoxy Ethanol). A warm final
wash should be made using a mild soap or detergent
solution and ending with a through rinsing with clean
water.
IMPORTANT: Some cleaning compounds may
attack the polycarbonate material,
resulting in cracks that will weaken
the material. Never use substances
such as Trichloethylene, Carbon
Tetrachloride or petroleum products.
Thoroughly rinse the windows after washing and dry
with clean, soft towels.
To minimize scratches and improve visibility by filling
in existing scratches, it is recommended that the
windows be waxed regularly. Some of the several
commercially available waxes that are recommended
include: Johnson’s Paste Floor Wax, McGuire Mirror
Glaze and Mirror Bright Polish Co. MGH-10.
IMPORTANT: If cracks or surface crazing are
observed, replace windshield.
OUT1739,000024C –19–05AUG02–1/1
Adding 12—Volt Accessories
IMPORTANT: This machine is equipped with two
12-volt 10-amp outlets.
Converter capacity requirements depend on the load of
the accessories installed. Follow electronic dealer and
manufacturer’s recommendations to determine the
capacity of the converter required and its installation
requirements. If standard equipment, verify if
amperage is adequate for application.
IMPORTANT: DO NOT connect an accessory to
one battery. Connecting a 12-volt
accessory to one battery will cause
one battery to overcharge, and the
other battery to undercharge,
causing battery failure.
4-1-7 081407
PN=163
To Next Page
Loading...
Need help?
General
