17
Charger Operations Continued
The following steps describe how to setup the RDX1 Mini: In this example we are setting up the charger to
charge a 3 cell (11.1v) 2000mAh Lithium Polymer battery pack.
BATT/PROGRAM
LiPo BATT
→
START/ENTER
START
/ENTER
BATT/PROGRAM Select: Press the INC or DEC buttons to scroll
through the battery programs, press START/ENTER to enter the
Lithium Polymer Battery (LiPo BATT) Program.
MODE Select: Press the INC or DEC buttons to scroll through the
battery programs, press START/ENTER to enter the Lithium Polymer
Battery (LiPo BATT) Program.
BATTERY Setting: Press the INC or DEC buttons to scroll through
the battery programs, press START/ENTER to enter the Lithium
Polymer Battery (LiPo BATT) Program.
The battery cell number will start to blink. Press INC or DEC to change the
value to the desired setting, press START/ENTER to con rm your setting.
LiPo BALANCE
2.0A 11.v (3s)
→
→
START/ENTER
START
/ENTER
LiPo BALANCE
2.0A 11.v (3s)
→
LiPo BALANCE
2.0A 11.1v (3s)
BEFORE STARTING THE PROCESS MAKE SURE YOU HAVE SETUP THE CHARGER
PROPERLY. NEVER LEAVE THE CHARGER UNATTENDED WHILE IT IS IN OPERATION.
Warning
To Next Page
Loading...
Need help?
General
