13
Battery Type Operation Operation Description
LiPo
Lilon
LiFe
LiHV
CHARGE
The charge mode is for charging LiPo/LiFe/LiIon/
LiHV batteries in normal mode.
DISCHARGE
This mode is for discharging
LiPo/LiFe/LiIon/LiHV batteries.
STORAGE
This program is for charging or discharging a
lithium battery which will not be used again for
an extended period of time.
FAST CHG
A fast charge will result in a smaller than usual
charging capacity but will reduce the total
charge time.
BAL CHARGE
This mode is for balancing the voltage of
LiPo battery cells while charging.
Available Operations
Depending on battery type, dierent operations will be available. This
chart shows which operations are available for the dierent types of
batteries the RDX1 is capable of working with.
Getting Started
Initial Setup of the Charger
After connecting the battery you are now ready to setup the charger to
charge your specic type of battery. When the charger is rst powered on,
you will enter the PROGRAM SELECT (01) mode by default. The default
mode of the charger is for a regular charge mode of a 2 Cell 2000 mAh
Lithium Polymer battery. If this is not the battery you plan on working with
then you will need to make changes to the operation programming based
on the following instruction.
BEFORE SELECTING AN OPERATION, IT IS CRITICAL THAT YOU
KNOW THE TYPE OF BATTERY YOU ARE WORKING WITH AND WHAT
THE MANUFACTURER RECOMMENDATIONS ARE FOR CHARGING OR
DISCHARGING. FAILURE TO FOLLOW THE MANUFACTURERS REC
OMMENDATIONS CAN RESULT IN DAMAGE TO THE BATTERY AND
POSSIBLE EXPLOSION.
Warning
To Next Page
Loading...
Need help?
General
