c
OM 2012
SECTION 2. PREPARATION FOR USE, SiOKAGE , OR SH JPPlt\(G
1. Preparation far Use
A. General
.
These instructiora are based on the assumption that the tow tractor-mounted unit
b properly installed on the tractor and that all necessary fuel and electrical con-
nections have been mode.
Hobart Brothers Company do& not build on aircraft
tow tractor.
Generator sets fcr tractor mounting are installed by the customer,
or ‘trac’tor manufacturer. Other generatar sets,
when ordered with truck or trailer,
are moimted at the Hobart factory and are shipped in running condition and ready
for operation after inspection and check.
’
CAUTION :
READ OPERATING IMlXUCTlOf’JS IN SECTION l-3 BEFORE
OPERATIluG THE UN IT.
B.
Inspection/Check
Inspect the unit thoroughly prior to oFration..
(1) Remove blacking, banding, ties, and- othei securing
i2) inspect exterior for shipping damage such as broken
metal, etc.
material.
I ighk , damaged sbee t
(3). Open all canopy doors and inspect intericr foe foreign n#teriaI such as rags,
too&, shipping papers, etc.
.
(4) Check fuel, coolant, and oil hoses and connections for vkible leak. Visually
inspect the compartment fioor and ground surface under the unit fcr signs of
leakoge. If leaks ore found, ccrrect by tightening hose clomps, tube fittings,
etc.,
os required.
(5) Check s&urity of tracts mounted getieratcr set retaining components (Sect.
2-1, Fig, 2) .
(6) Check rh e 0 owing for sufficient quantity: f II
(a) Fuel
Turn ON panel lights to energize fuel gage when engine is stopped.
(Tractor-mounted units ore rupplied from the tow tractor tank.)
Aug 25’85
.
l-2
Pabe 1
To Next Page
