10
6 Settings
Attention:
machine has to be switched off.
– Open hood, push Program button
➃
and Drain button
➂
simultaneously until at the temperature indicator Rinse
➅
"boF" appears.
If no button is pressed during next 10 secs., the indicator
switches off and the new settings will be saved.
6.1 Adjustment of detergent dosage quantity
(delivery values are only valid with built-in HOBART dispenser)
– Push Program button
➃
again.
The temperature indicator Rinse
➅
displays:
"CH1" = adjustment of the detergent dosage quantity.
The temperature indicator Wash
➄
displays e.g.:
"21" = pre-adjusted value of the detergent dosage time =
21 sec. ≈ 2,4 g/l.
– To adjust the detergent dosage time, push Start button
➁
repeatedly, until the desired value (0 - 50 sec. ≈ 0 - 6 g/l)
appears at the Wash indicator
➄
.
(Adjustment should be done in accordance with chemical
suppliers recommendations.)
6.2 Adjustment of rinse agent dosage quantity
– Push Program button
➃
again.
The temperature indicator Rinse
➅
displays:
"CH2" = adjustment of the rinse agent dosage quantity.
The temperature indicator Wash
➄
displays e.g.:
"19" = pre-adjusted value of the rinse agent dosage time =
19 sec. ≈ 0,3 g/l.
– To adjust the rinse agent dosage time, push Start button
➁
repeatedly, until the desired value (0 - 50 sec. ≈ 0 - 0,8 g/l)
appears at the Wash indicator
➄
.
(Adjustment should be done in accordance with chemical
suppliers recommendations.)
6.3 Adjustment of water hardness (with optional softener only)
To adjust the softener to the local water hardness (obtain details
from local water authority):
– Push Program button
➃
again.
The temperature indicator Rinse
➅
displays:
"H02" = adjustment of the softener (if built in).
– Push Start button
➁
repeatedly, until the required value
(H01 - H03) appears at the temperature indicator Rinse
➅
.
H01 = up to 10° eh / H02 = 11 to 20° eh / H03 = 21 to 30° eh
water hardness (eh = Clark).
To Next Page
Loading...
Need help?
General
