8
3 1 7 4 2 5
8 6
4 Controls
➀
Machine ON / OFF By pushing this button the machine will be switched on.
(illuminates during operation) In case of emergency (e.g. faults), it is possible to switch off
the machine immediately without drain cycle, by pushing this
button again.
After switch off, the machine is not voltage free!
➁
Start button This button illuminates to indicate the mode of the machine:
RED = machine fills and starts heating
GREEN = machine is ready for operation
BLUE = selected program is running
AUXXT models only: High pressure cleaning
Never use for cleaning glasses and light dishes
(breakage) !
High pressure mode for a running cycle will be activated by
short pushing the blue illuminated Start button (not possible
within the first 5 seconds after cycle start).
By pushing and holding (3 sec.) the Start button, high
pressure mode will be activated permanently.
➂
Drain button By pushing and holding (2 sec.) this button, the drain and
(illuminates during operation) self cleaning cycle starts. At the end of the cycle, the
machine switches off automatically.
After switch off, the machine is not voltage free!
➃
Program button By pushing this button, it is possible to select between
different pre-set programs, according to the model and
equipment. The program no. (e.g. P02) appears at the rinse
temperature indicator
➅
.
➄
Temperature indicator Wash (°C) Indicates only on demand (see chapter 8).
➅
Temperature indicator Rinse (°C) Indicates only on demand (see chapter 8).
➆
Salt required Indicating the need for regeneration salt to be added.
(Only with built-in softener.)
➇
Service indicator Indicating, that the machine has a fault.
To Next Page
Loading...
Need help?
General
