13
– Select program:
The machine is operating automatically with standard cycle time.
If needed, it is possible to select a shorter or longer program.
To show the present program, push Program button
➃
before
starting the wash cycle. To change the program, push Program
button again.
P 01 = Short cycle (for light / medium soiled dishes and
glassware)
P 02 = Standard cycle (for medium / heavy soiled dishes)
P 03 = Long cycle (for dried on soiling and containers)
P 04 = Endless cycle
An endless cycle will be indicated by moving light points
at the temperature indicators.
To stop the wash cycle, push Start button
➁
. (After
20 minutes the machine will stop automatically.)
After a short break, rinse starts automatically.
The machine continues with the chosen cycle time until
switch off.
High pressure cleaning (AUXXT models only)
Never use for cleaning glasses and light dishes
(breakage) !
High pressure mode for a running cycle will be activated
by short pushing the blue illuminated Start button (not
possible within the first 5 seconds after cycle start).
By pushing and holding (3 sec.) the Start button, high
pressure mode will be activated permanently until the
progam will be changed or the machine is switched off.
At the temperature indicator Rinse appears "HP".
8 Preview of temperatures
– Press and hold (3 sec.) Program button
➃
until the indicators
Wash
➄
and Rinse
➅
show the actual temperatures (°C).
The indicators go out 10 sec. after releasing Program button.
Permanent temperature display can be activated on request by
the service technician.
To Next Page
Loading...
Need help?
General
