11
6.4 AGITATOR.
To install an agitator, the bowl must be on the bowl support and fully lowered.
To Install
1. Open the wire cage.
2. Place the agitator inside the bowl and line up the
horizontal slot on the agitator with the agitator shaft
pins.
3. Slide the agitator up the agitator shaft until it stops
and latches.
To Remove
1. Open the wire cage.
2. Lower the bowl by pressing and holding the down
arrow on the bowl switch.
3. Hold the agitator and pull the plunger of the
agitator out (Fig. 4). Slide the agitator down off
the agitator Shaft.
6.5 HOLD-TO-RUN OPERATION.
Use extreme caution whilst operating the hold to run facility when the bowl is
not in the upper position.
Figure 4.
The Legacy mixer has a hold-to-run STIR feature that allows the mixer to be operated in
a STIR mode with the bowl in the down position. This allows the agitator to be gradually
engaged with the ingredients improving the blending and reducing the dust emission. The
start button must be continuously held to operate the mixer in the STIR mode. The bowl
can be raised or lowered at the same time whilst the agitator is rotating.
6.6 POWER BOWL LIFT.
CAUTION: Before lowering the bowl onto a bowl truck, always unlock bowl and
swing bowl out slightly.
To raise the bowl, the bowl must be in the locked position. Push and hold the up arrow
on the bowl switch. To lower the bowl, push and hold the down arrow on the bowl switch.
To Raise the Bowl while Mixing
To raise the bowl while the agitator is mixing the product (when required by recipe or
when using the Bowl Scraper Attachment):
1. Close the wire cage, and then select a mixing speed on the SPEED dial.
2. Select a countdown time or HOLD for continuous count-up mixing.
3. While pressing and holding the up arrow on the bowl switch, press and hold the
START button.
4. When the bowl reached the mix position, release the START button. The mixer
automatically changes to the selected mixing speed.
To Next Page
Loading...
Need help?
General
