10. Built-in devices
114
To operate
Start / stand-by screen
A few seconds after the control panel has been connected to the
power supply, a start screen will appear.
If nothing is entered for several minutes, a stand-by screen will
automatically be displayed.
Functions
The functions in the menu lines lm of the control panel can be
selected in any sequence. The operating parameters are shown in
the status line
k
or in the display no
.
When the time is set (see “Setting the time”) the display
alternates between the time and the room temperature
that has been set. If no time has been set, the set room
temperature will be displayed permanently.
To switch on/o
To switch on
• Press the adjusting knob / pushbutton.
Previously set values / operating parameters will be re-
activated after the control panel has been switched on.
To switch o
• Press the adjusting knob / pushbutton for longer than 4 seconds.
iNet-ready: After 2 seconds, “APP” appears on the display;
after a further 2 seconds, “OFF” appears on the display.
Due to an internal lag feed in the heating or air-condi-
tioning system, it may take a few minutes for the Truma
CP plus control panel to switch o.
Selecting the setting mode
Press the adjusting knob / pushbutton
The display shows the setting mode. The rst icon blinks.
To Next Page
Loading...