Using the device 37
USING THE DEVICE
COMMISSIONING
Before commissioning the device, read section
„Safety Information“ (starting from page 12).
1.
Set up the device according to the installation
requirements (see page 15).
2. Connect the power supply to the device.
3. Connect the mains cable to the power supply and
its plug to a power socket.
4.
The device starts up and successively displays a
welcome text, the device type, its software version
and the current number of therapy hours and then
switches to the date and time display (standby
mode).
5.
Connect the therapy tube to the mask (5a) and the
unattached end of the tube to the air outlet (5b).
If you are using a bacterial fi lter, fi t it between the
tube and air outlet (5c).
6.
Calibrate the device as described in the chapter
„Calibration“ from page 71.
JAB122020
2
5b
5c
5a
To Next Page
Loading...
