58 Device functions
PRESSURE
(only point 2 CPAP and point 2 AutoCPAP and point 2
BILEVEL ST20 in CPAP mode)
Selection of pressure by the physician
When the pressure parameter is changed during
therapy/titration, the device adapts to the new
setting slowly (25 Pa/s). This pressure ramp can
be deactivated using the TRENDset PC software.
point 2 CPAP:
1. Select the complete menu (see page 45).
2. Use the selection keys
and to select
Press..
3. Press the the enter key and if necessary,
input the PIN code with the selection keys
and . Press the enter key after every digit.
4. Press the enter key and then use the selec-
tion keys and to set the desired value.
Confi rm your setting by pressing the enter key
.
4%/!*1
Q .!00MMMMMMB @$
To Next Page
Loading...
